![]() Take a carabiner keychain and attach it to the nylon webbing so that you can clip the quiver onto your belt loop.įor now, I like using it clipped onto a belt loop, but I may design a back harness setup down the road. If your canvas is longer than your inner assembly (like mine was) trim it so it is about 2 inches past the top of the quiver, then turn the edge down for a decorative edge. 129.99 Select options Just Plain Arrows 82.50 165.00 Select options Signed Hard Cover Secrets & Science book. Turn the tube right-side out and slide it onto the assembled quiver innards. Place the nylon webbing in place around the PVC and wood assembly. I lined the inside with rolled up utility mat, used an old belt for the shoulder strap. cut out a circle of canvas and sew it to one end of the tube. Here is my version of the homemade pvc quiver, 3' pvc painted misc dark colors, one M4 3 mag molle pouch on top and a large single pouch on bottom, wrapped in camo print fabric and camo color t-shirt strips. Slide it off and stitch it up to make a tube. The pictures are in stages, but we really should have took more. Wrap the inside-out canvas loosely around the PVC and pin it. 1 choctawlb Senior Member We got some shipping tubes from a friend a few weeks ago, and this is Will's first attempt at a 'Dawgware' style quiver. The kit is shipped to you with a 1 to 1 scale drawing, leather, laces, and sewing thread for the add-on. The quiver is positioned low and behind your back or low and at your side. Glue a Popsicle stick to each end of the arrows then glue those to the wood that forms where you. Pic 1: Pic 2: It allows you to draw an arrow, either through the side of the quiver, or out the top of the quiver. ![]() Some quick work with a needle and thread will turn the nylon webbing into a sling that will support the quiver and give you a place to attach the quiver to a clip. Make your own Hill-style back quiver with this kit. Cut out a part where there would be a strap around the body. Since I don't have access to a lathe I had to use a knife to carve a recess into the top edge of the wooden plug so that it fits into the end of the PVC pipe.Ī little elmer's glue around the edge will fill in any imperfections in the fit between the carved plug and the PVC pipe. Using sandpaper I smoothed the edges of the PVC pipe and the wooden plug ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |